Matte Color High Polymer Self-Adhesive Waterproof Roll Roof Waterproof Membrane

Description

It is a tire – free self- adhesive waterproof coil with a matte sun resistant blue film! Effectively avoid roof light pollution, no reflection, with a certain heat insulation effect and other performance, a tear a paste, convenient construction, the surface of the blue film greatly improves the service life of the coil, especially suitable for color steel roof waterproof leak repair engineering construction.

SELF-ADHESIVE COIL (DRY LAYING METHOD)

1. Before pasting the coil, there should be no dust, sundries, moisture a t the base. If the base is rusted, use primer glue to brush and then paste. When pasting coil material, the roof should be placed from the low to the high (along the water direction), overlapping lap should be in the opposite direction of the downpipe.
2. When pasting the rolling material, the self-adhesive bottom surface isolation paper should be torn. Before the large area of the overlay should be done Yin and Yang Angle additional layer and node sealing treatment.
3. When rolling the roll, the waterproof roll should be slightly tightened and not too slack. The air under the roll should be excluded and compacted with a press roll. After plastered 24 less than shall not be water, should do a good job of product protection measures.

SELF-ADHESIVE COIL (WET PAVING METHOD)

1. Clean the surface of the base. The base can be wet, but there can be no Ming water.
2. Using 42.5R general silica cement to prepare the polymer slurry, stir the compound rubber powder and cement evenly according to the weight ratio of 1:10, add water to make the slurry, the water-cement ratio is 0.4, stir with and electric mixer for 1~2 minutes, mix well and stand for 5~8 minutes before use.
3. Use a scraper to evenly paint the mixed polymer cement slurry on the base, while scraping the polymer mortar, the waterproof coil is pastedd on the top, top, and the the eexhaust roll and stick firmly. After paving and pasting, the lap edge of the coil should be checked in time to prevent empty drum and warped edge.
4. The joints of the two adjacent rolls are lapped. During construction, the reserved isolation belt of the self-adhesive edge can be torn off and pasted directly.

Matters needing attention:
1) Coil should be stored in a dry and ventilated environment. Different types and specifications of coil should be stacked separately.
2) The storage temperature is not more than 45°C, the horizontal storage of the coil stacking height is not more than five layers, vertical
storage single-layer stacking.